HP Codemaster 100 - Restoring Factory Settings

6HWXSDQG&RQILJXUDWLRQ
Configuring the CodeMaster 100
2-9
9 Repeat steps 5 through 8 until you are finished configuring the settings in Setup
Menu 1.
10 Depress both sides of the ECG Size key simultaneously to return to the
Setup/Diagnostic Menu.
11 To change settings in Setup Menu 2, select
SETUP MENU 2
from the
Setup/Diagnostic Menu and repeat the above steps.
12 Turn the Energy Select control to Off to exit Setup/Diagnostic mode.
Restoring Factory Settings
You can use the factory setting for most values by selecting
RESTORE FACTORY
SETTINGS
from the Setup/Diagnostic Menu. Highlighting and selecting this
setting does NOT bring up an additional menu. Selecting this line will undo user
configured parameters and restore factory defaults. This process restores factory
settings on the defibrillator/monitor and not on the 12-Lead option.
HP recommends that you not use the 12-Lead option to acquire, view, store,
print or transmit when in Diagnostic Mode as the ECG may be lost and the
12-Lead capability may be reset.
WARNING