8
Contents
Setting the MPC5xx Configuration Options 81
To configure the processor type 81
To configure the processor clock speed 82
To configure the debug port connection type 83
To configure the reset configuration word source 84
To configure the “Break In” type 84
To configure the Trigger Out BNC 85
To configure the Trigger In BNC 85
To configure the BNC break type 86
To configure restriction to real-time runs 86
Testing the Emulation Probe/Module and the Target System 87
To test memory accesses 87
To test by running a program 87
5Using Debuggers
Setting Up Debugger Software 92
To change the port number of an emulation probe/module 93
To view logic analysis system windows next to the debugger 93
Using the Green Hills Debugger 95
To get started 95
To configure using an initialization script 98
To perform common debugger tasks 99
To send commands to the emulation probe/module 100
To view commands sent by MULTI to the emulation probe/module 100
To reinitialize the system 101
To disconnect from the emulation probe/module 101
Error conditions 101
To Next Page
Loading...
Need help?
General
