92
Chapter 5: Using Debuggers
Setting Up Debugger Software
Setting Up Debugger Software
The instructions in this section assume that your PC or workstation is
already connected to the LAN and that you have already installed the
debugger software according its documentation.
To use your debugger with the emulation probe/module:
1. Install the emulation probe/module (see the “Installing the Emulation
Probe” chapter on page 13 or the “Installing the Emulation Module”
chapter on page 43).
2. Connect the emulation probe/module to your target system (see the
“Connecting to a Target System” chapter on page 63).
3. If you are using the debugger with an emulation module in a logic analysis
system, you must connect the logic analysis system to the LAN (see “To
connect the logic analysis system to the LAN” on page 59).
4. If you want to display logic analysis system windows next to your debugger
windows, export the logic analysis system’s display to your PC or
workstation (see “To view logic analysis system windows next to the
debugger” on page 93).
5. Configure the emulation probe/module (see the “Configuring the
Emulation Probe/Module” chapter on page 75).
If you use the logic analysis system’s Emulation Control Interface to
configure the emulation probe/module, remember to end the Emulation
Control Interface session before you start the debugger.
CAUTION: Do not use the Emulation Control Interface at the same time as a debugger.
The Emulation Control Interface and debuggers do not keep track of
commands issued by other tools. If you use both at the same time, the tools
may display incorrect information about the state of the processor, possibly
resulting in lost data.
6. Begin using your debugger.
See Also
Refer to the documentation for your debugger for more information on
connecting the debugger to the emulation probe/module.
To Next Page
Loading...
Need help?
General
