61
Chapter 2: Installing the Emulation Module
Preparing for a Debugger
To verify LAN communication with the
emulation module
1 Telnet to the IP address.
For example, on a UNIX system, enter “telnet <IP_address> 6472".
This connection will give you access to the emulation module’s built-in
terminal interface. You should see a prompt, such as “M>”.
2 At the prompt, type:
ver
You should then see information about the emulation module and
firmware version.
3 To exit from this telnet session, type Ctrl-d at the prompt.
See Also For information on physically connecting the logic analysis system to
the LAN and configuring its LAN parameters, see the installation guide
or on-line help for your logic analysis system.
To Next Page
Loading...
