HP E3456A User Manual

36
Chapter 1: Installing the Emulation Probe
Connecting a Terminal to the Emulation Probe’s Serial Port
To verify serial communications
1 Start a terminal emulator program on the host computer.
If you are using a PC, the Terminal application in MS Windows 3.1, or
the HyperTerminal application in MS Windows 95/NT, will work fine.
If you are using a UNIX workstation, you can use a terminal emulator
such as cu or kermit.
2 Plug the power cord into the emulation probe.
When the emulation probe powers up, it sends a message (similar to
the one that follows) to the serial port and then displays a prompt:
6HULDO&DEOH3LQRXW
3LQ1XPEHU 6LJQDO 6LJQDO'HVFULSWLRQ
 '&' 'DWD&DUULHU'HWHFWQRWXVHG
 7' 7UDQVPLW'DWDGDWDFRPLQJIURP+3 HPXODWLRQSUREH
 5' 5HFHLYH'DWDGDWDJRLQJWR+3 HPXODWLRQSUREH
 '75 'DWD7HUPLQDO5HDG\QRWXVHG
 *1' 6LJQDO*URXQG
 '65 'DWD6HW5HDG\2XWSXWIURP+3 HPXODWLRQSUREH
 576 5HTXHVWWR6HQG,QSXWWR+3 HPXODWLRQSUREH
 &76 &OHDUWR6HQGFRQQHFWHGWRSLQ
 5,1* 5LQJ,QGLFDWRUQRWXVHG

HP E3456A Specifications

General

Brand	HP
Model	E3456A
Category	Control Unit
Language	English