102
Chapter 5: Using Debuggers
Using the Green Hills Debugger
For an emulation module, see “To display current firmware version
information” on page 56. If the emulation module is not programmed with
the proper firmware, see “To update firmware using the Emulation Control
Interface” on page 56.
“command socket connection failed: WSAECONNREFUSED: connection refused”
This message usually means the emulation probe/module is not at port
#6470 on the logic analysis system.
See Also Green Hills MULTI Software Development Environment User’s
Guide.
Using MULTI with the Hewlett-Packard Processor Probe from Green
Hills Software, Inc.
The Green Hills web site: http://www.ghs.com
See the “Configuring the Emulation Probe/Module” chapter on page 75
for more information on configuration options and the “cf” command.
To Next Page
Loading...
