116
Chapter 5: Using Debuggers
Using the Software Development Systems Debugger
Interface” on page 56.
“command socket connection failed: WSAECONNREFUSED: connection refused”
This message usually means the emulation probe/module is not at port
#6470. See “To change the port number of an emulation probe/module”
on page 93.
“unrecognized hostname”
This message usually means that the debugger is unable to establish
communication with the emulator.
• Verify communication to the emulation probe/module by doing a ping to
the emulation probe or to the logic analysis system.
If you are unable to ping the emulator probe or logic analysis system, refer
to “Solving LAN Communication Problems” on page 31 or the logic analysis
system on-line help, respectively, for more information.
See Also
The SDS web site: http://www.sdsi.com
The SDS SingleStep Users Guide.
See the “Configuring the Emulation Probe/Module” chapter on page 75
for more information on configuration options and the “cf” command.
To Next Page
Loading...
Need help?
General
