HP E3456A - Page 129

127
Chapter 6: Solving Problems
Built-In Commands
The prompt indicates the status of the emulation probe/module:
([DPSOHV To set register R0, then view R0 to verify that it was set, enter:
R>rst -m
M>reg r0=ffff
M>reg r0
reg R0=0000ffff
To break execution then step a single instruction, enter:
M>b
M>s
PC= xxxxxxxx
M>
To determine what firmware version is installed in the emulation probe/
module, enter:
M>ver
See Also Use the help command for more information on these and other
commands. Note that some of commands listed in the help screens are
generic commands for HP emulators and may not be available for your
product.
If you are writing your own debugger, contact HP for more information.
(PXODWLRQSUREHPRGXOHSURPSWV
8 5XQQLQJXVHUSURJUDP
0 5XQQLQJLQEDFNJURXQGPRQLWRU
S 1RWDUJHWSRZHU
5 (PXODWLRQUHVHW
U 7DUJHWUHVHW
"8QNQRZQVWDWH