146
Chapter 6: Solving Problems
Solving Emulation Module Problems
p>pv -t5 -v2 1
Testing: HPE3499A Series Emulation System
Test # 5: Target Probe Feedback Test failed!
Bad 20 Pin Status Read when unconnected = 0x7fb7
Expected Value = 0xffb7
Bad 20 Pin Status Read when connected = 7fb7
Expected Value = 0x7fb7
Output 19 Low not received on Input 11
Output 11 Low not received on Input 19
Output 13 Low not received on Input 1
Output 12 High not received on Input 6
Output 12 and Input 6 not pulled high on release
Output 8 Low not received on Input 10
Output 7 Low not received on Input 20
Output 4 Low not received on Input 14
Output 2 Low not received on Input 18
FAILED Number of tests: 1 Number of failures: 1
If the you get a verbose output like this, check to make sure that the
loopback test board was connected properly.
TEST 6: Boundary Scan Master Test
TEST 7: I2C Test
If these tests are not executed, check that you have connected the
loopback test board.
If these tests fail, return the emulation module to HP for replacement.
To Next Page
Loading...
Need help?
General
