88
Chapter 4: Configuring the Emulation Probe/Module
Testing the Emulation Probe/Module and the Target System
2 Use the Load Executable window to download the program into
RAM or flash memory.
3 Use the Breakpoints window to set breakpoints. Use the
Registers window to initialize register values.
The new register or breakpoint values are sent to the processor when
you press the Enter key or when you move the cursor out of the
selected register field.
4 In the Run Control window, click Run.
5 Use the Memory Mnemonic window to view the program and use
the Memory window to view any output which has been written
to memory.
To Next Page
Loading...
Need help?
General
