Chapter 2
Installing the System
Setting Up the hp Integrity Superdome or hp 9000 Superdome
49
Figure 2-27 Five-Wire Connector
Use the following procedure to install the PDCA:
Step 1. Make sure the circuit breaker on the PDCA is Off.
Step 2. Remove the rear PDCA bezel by removing the four retaining screws.
Step 3. Run the power cord down through the appropriate opening in the floor tile.
Step 4. Insert the PDCA into its slot and secure with four screws.
L1 PE
L3 N
L2
To Next Page
Loading...
