HP Integrity Superdome SX1000 - Page 62

Chapter 2
Installing the System
Setting Up the hp Integrity Superdome or hp 9000 Superdome
50
Figure 2-28Installing the PDCA
Step 5. Using a T20 Torx driver, attach the four screws that hold the PDCA in place.
Step 6. If required, repeat Step 3 through Step 5 for the second PDCA.
Step 7. Re-install the rear PDCA bezel.
CAUTION Do not check voltages with the PDCA breaker set to On. Make sure the electrical
panel breaker is On and the PDCA breaker is Off.
Step 8. Plug in the PDCA connector.
Step 9. Check the voltage at the PDCA.
1. Using a T20 Torx driver, remove the screw on the hinged panel at the top of the PDCA. Refer to
Figure 2-29.
2. Using a Volt-Ohm meter (VOM), check the following test points to make sure they conform to
the specifications for the PDCA and local electrical specifications:
If the voltage values do not match the specifications, have the customer contact an electrician to
troubleshoot the problem.