Need help?Do you have a question about the HP ProCurve 2910al Switch and is the answer not in the manual?
General| Model | HP ProCurve 2910al Switch |
|---|---|
| Layer | Layer 3 |
| Jumbo Frame Support | Yes |
| Power Device | Internal power supply |
| VLAN Support | Yes |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Ports | 24 or 48 x 10/100/1000 ports |
| Uplink Ports | 4 x SFP (mini-GBIC) |
| Stacking | Yes |
| MAC Address Table Size | 32000 entries |
| Routing Protocol | RIP, OSPF, BGP, IGMP |
| Remote Management Protocol | SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP |
| Features | VLAN, QoS, IPv6, ACLs |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af |
| Operating Temperature | 0 to 45°C |
| Operating Humidity | 15% to 95% (noncondensing) |
| Power over Ethernet (PoE) | PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models |
To Next Page