HP ProCurve 2910al Switch User Manual

Multimedia Traffic Control with IP Multicast (IGMP)
CLI: Configuring and Displaying IGMP
Configuring IGMP Traffic Priority.
Syntax: vlan < vid > ip igmp high-priority-forward
This command assigns “high” priority to IGMP traffic or
returns a high-priority setting to “normal” priority. (The
traffic will be serviced at its inbound priority.) (Default:
normal.)
ProCurve(config)# vlan 1 ip igmp high-priority-forward
Configures high priority for IGMP traffic on VLAN 1.
ProCurve(vlan-1)# ip igmp high-priority-forward
Same as above command, but in the VLAN 1 context level.
ProCurve(vlan 1)# no ip igmp high-priority-forward
Returns IGMP traffic to “normal” priority.
ProCurve> show ip igmp config
Show command to display results of above high-priority
commands.
Configuring the Querier Function.
Syntax: [no] vlan <vid> ip igmp querier
This command disables or re-enables the ability for the switch
to become querier if necessary. The no version of the command
disables the querier function on the switch. The show ip igmp
config command displays the current querier command.
(Default Querier Capability: Enabled.)
2-11

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models