Configuring an HPE Smart Array Gen10 controllerConfiguring an HPE Smart Array Gen10 controller
ProcedureProcedure
1. Power up the server .
2. If you are running the server in UEFI Boot Mode, select the boot options.
3. Update the drive firmware if it is not the latest revision.
4. (Optional) If running the server in Legacy Boot Mode, set the controller as the boot controller.
5. (Optional) If running the server in Legacy Boot Mode, change the controller boot order.
6. If the new controller is not the new boot device, install the device drivers.
7. If the controller firmware is not the latest version, use SPP to update it.
8. Use UEFI System Utilities or HPE Smart Storage Administrator ( HPE SSA) to create arrays and logical drives.
See the following resources for more information:
SPP – See the product documentation on the Hewlett Packard Enterprise website:
http://www.hpe.com/info/spp/docshttp://www.hpe.com/info/spp/docs
UEFI System Utilities or HPE Smart Storage Administrator – See the HPE Smart Array SR Gen10 Configuration Guide on the
Hewlett Packard Enterprise website:
http://www.hpe.com/info/smartstorage-docshttp://www.hpe.com/info/smartstorage-docs
To Next Page
Loading...
