Preparing the Preparing the serverserver for installation for installation
ProcedureProcedure
1. Observe the following warnings:
WARNING: WARNING: The front panel Power On/Standby button does not shut off system power.
Portions of the power supply and some internal circuitry remain active until AC power is
removed.
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove
power from the server:
For rack and tower servers, remove the power cord.
For server blades and compute modules, remove the server blade or compute module
from the rack.
WARNING: WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center websiteHewlett Packard Enterprise Support Center website . Follow the instructions
on the website to update the system ROM.
3. If installed, remove the front bezel .
4. Power down the server.
5. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
6. Disconnect all peripheral cables from the server.
7. Remove the server from the rack .
8. Remove the access panel .
9. Proceed to Installing the TPM board and cover .
To Next Page
Loading...
