HP ProLiant DL20 Gen10 - Table of Contents

Table of contentsTable of contents
1 Component identification
1.1 Front panel components
1.1.1 Serial number/iLO information pull tab
1.2 Front panel LEDs and buttons
1.2.1 Server UID LED
1.2.2 UID button functionality
1.2.3 Front panel LED power fault codes
1.3 Rear panel components
1.4 Rear panel LEDs
1.5 System board components
1.5.1 System maintenance switch descriptions
1.5.2 DIMM slot locations
1.5.3 DIMM label identification
1.5.4 PCIe riser slot definitions
1.6 Drive LED definitions
1.6.1 Low-profile LFF drive LED definitions
1.6.2 Smart Carrier (SC) drive LED definitions
1.7 Drive bay numbering
1.8 Fan bay numbering
1.9 Fan mode behavior
2 Operations
2.1 Power up the server
2.2 Power down the server
2.3 Remove the front bezel
2.4 Extend the server from the rack
2.5 Remove the server from the rack
2.6 Install the server into the rack
2.7 Remove the access panel
2.8 Install the access panel
2.9 Remove the riser cage
2.10 Install the riser cage
3 Setup
3.1 Initial server installation
3.1.1 HPE Installation Service
3.1.2 Setting up the server
3.2 Operational requirements
3.2.1 Space and airflow requirements
3.2.2 Temperature requirements
3.2.3 Power requirements
3.2.4 Electrical grounding requirements
3.3 Rack warnings and cautions
3.4 Server warnings and cautions