HP ProLiant DL20 Gen10 - Installing the Flexiblelom Adapter

Installing the FlexibleLOM adapterInstalling the FlexibleLOM adapter
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Remove the access panel .
7. Remove the FlexibleLOM riser cage .
8. Remove the FlexibleLOM slot blank.
9. Install the FlexibleLOM adapter.
10. Install the FlexibleLOM riser cage .
11. Install the access panel .
12. Install the server into the rack .
Installing the FlexibleLOM adapter 142