Install the server into the rackInstall the server into the rack
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-25 Torx screwdriver available.
ProcedureProcedure
1. Install the server into the rack:
a. Insert the server sliding rails into the rack mounting rails.
b. Slide the server into the rack until the chassis ears are engage with the rack column.
2. Do one of the following:
For a server that has thumbscrew chassis ears , tighten the captive thumbscrews.
For a server that has quick-release latch chassis ears , if necessary, open the latches and tighten the shipping screws.
To Next Page
Loading...
