Rack warnings and cautionsRack warnings and cautions
WARNING:WARNING:
To reduce the risk of personal injury or equipment damage when unloading a rack:
At least two people are needed to safely unload the rack from the pallet. An empty 42U rack
can weigh as much as 115 kg (253 lb), can stand more than 2.1 m (7 ft) tall, and might
become unstable when being moved on its casters.
Never stand in front of the rack when it is rolling down the ramp from the pallet. Always
handle the rack from both sides.
WARNING:WARNING:
When all components are removed, the server weighs 6 kg (13.22 lb). When all components are
installed, the server can weigh up to 9.46 kg (20.85 lb).
Before configuring your rack solution, be sure to check the rack manufacturer weight limits and
specifications. Failure to do so can result in physical injury or damage to the equipment and the
facility.
WARNING:WARNING:
To reduce the risk of personal injury or damage to the equipment, be sure that:
The rack has anti-tip measures in place. Such measures include floor-bolting, anti-tip feet,
ballast, or a combination as specified by the rack manufacturer and applicable codes.
The leveling jacks (feet) are extended to the floor.
The full weight of the rack rests on the leveling jacks (feet).
The stabilizing feet are attached to the rack if it is a single-rack installation.
The racks are coupled together in multiple rack installations.
WARNING:WARNING:
The chassis is heavy. To reduce the risk of personal injury or damage to the equipment, do the
following:
Observe local occupational health and safety requirements and guidelines for manual
material handling.
Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. The chassis weighs more than 6 kg (13.22 lb), so at least
two people must lift the chassis into the rack together. An additional person may be
required to help align the chassis if the chassis is installed higher than chest level.
Use caution when installing the chassis into or removing the chassis from the rack.
Adequately stabilized the chassis before extending a component outside the rack. Extend
only one component at a time. The rack might become unstable if more than one component
is extended.
Do not stack anything on top of rail-mounted component or use it as a work surface when
extended from the rack.
WARNING:WARNING:
The rack rails form only a shelf for the chassis to rest on. The chassis is not attached to the rails
by any other means. Slipping and falling chassis will cause bodily injury or damage the chassis,
so use extreme care when pulling the chassis out from the rack. Hewlett Packard Enterprise is
not responsible for any injury or damage caused by the mishandling of the chassis.
CAUTION:CAUTION:
Before installing the server into a rack , be sure to properly scope the limitations of the rack . Before proceeding with
To Next Page
Loading...
