Remove the riser cageRemove the riser cage
CAUTION:CAUTION:
To prevent damage to the server or expansion boards, power down the server, and disconnect all power cords before
removing or installing the riser cage.
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Remove the access panel .
7. If installed, disconnect all cables connected to existing expansion boards.
8. Remove the riser cage.
To Next Page
Loading...
