HP ProLiant DL20 Gen10 - Installing the TPM Board and Cover

Installing the TPM board and coverInstalling the TPM board and cover
ProcedureProcedure
1. Observe the following alerts:
CAUTION: CAUTION: If the TPM is removed from the original server and powered up on a different server, data stored in the
TPM including keys will be erased.
CAUTION: CAUTION: The TPM is keyed to install only in the orientation shown. Any attempt to install the TPM in a different
orientation might result in damage to the TPM or system board.
2. Align the TPM board with the key on the connector, and then install the TPM board. To seat the board, press the TPM board firmly
into the connector. To locate the TPM connector on the system board, see the server label on the access panel.
3. Install the TPM cover:
a. Line up the tabs on the cover with the openings on either side of the TPM connector.
b. To snap the cover into place, firmly press straight down on the middle of the cover.
Installing the TPM board and cover 155