Installing the rack rail optionInstalling the rack rail option
The rack rails can be installed in round-hole, square-hole, or threaded-hole racks. These rails occupy 1U position on the rack.
The illustrations used in this section show an icon on the upper right corner of the image. This icon indicates the rack type for which the
action illustrated in the image is valid.
IconIcon Rack typeRack type
Round-hole rack
Square-hole rack
Threaded-hole rack
ProcedureProcedure
1. Attach the sliding rails to the server:
a. Align the notches on the rail with the pins on the side.
b. Slide the rail towards the rear of the server to lock it into place.
2. Locate the orientation markers on the mounting rails.
The front end of the rails are marked FRONT LEFTFRONT LEFT and FRONT RIGHTFRONT RIGHT.
To Next Page
Loading...
