HP ProLiant DL20 Gen10 - Installing an Optical Drive in an SFF Chassis

Installing an optical drive in an SFF chassisInstalling an optical drive in an SFF chassis
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Remove the access panel .
7. Remove the media bay blank:
a. Remove the screws securing the media bay blank.
Retain the screws for installing the optical drive cage.
b. Disengage the media bay blank.
c. Remove the media bay blank.
8. Remove the optical drive blank.
Installing an optical drive in an SFF chassis 93