Riser slot 1
Riser slot 2
13. Install the riser cage.
14. Connect all necessary internal cabling to the expansion board.
For more information on these cabling requirements, see the documentation that ships with the option.
15. Install the access panel .
16. Install the server into the rack .
17. Connect all necessary external cabling to the new expansion board.
For more information on these cabling requirements, see the documentation that ships with the option.
18. Connect all peripheral cables to the server.
19. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
20. Power up the server .
21. If removed, install the front bezel .
The installation is complete.
To Next Page
Loading...
