3.5 Electrostatic discharge
3.6 POST screen options
4 Hardware options installation
4.1 Introduction
4.2 Rack rail option
4.2.1 Installing the rack rail option
4.2.2 Installing the rack rail hook-and-loop strap
4.3 Installing the front bezel option
4.4 Drive options
4.4.1 Drive installation guidelines
4.4.2 Drive support information
4.4.3 Installing an LFF non-hot-plug drive
4.4.4 Installing an LFF hot-plug drive
4.4.5 Installing an SFF hot-plug drive
4.5 Power supply options
4.5.1 Hot-plug power supply calculations
4.5.2 Power supply warnings and cautions
4.5.3 Installing a redundant AC power supply
4.5.4 Installing a hot-plug DC power supply
4.6 Optical drive option
4.6.1 Installing an optical drive in an LFF chassis
4.6.2 Installing an optical drive in an SFF chassis
4.7 Installing the two-bay SFF drive cage option
4.8 Memory options
4.8.1 DIMM population information
4.8.2 Installing a DIMM
4.9 M.2 SSD/dedicated iLO/serial port enablement option
4.9.1 M.2 SSD/dedicated iLO/serial port enablement option components
4.9.2 M.2 SSD standoffs in the system board
4.9.3 Installing the M.2 SSD/dedicated iLO/serial port enablement board
4.9.4 Installing the serial port cable
4.9.5 Enabling the dedicated iLO management module
4.10 M.2 SSD option
4.10.1 Installing the M.2 NVMe SSD on the system board
4.10.2 Installing an M.2 NVMe SSD on the M.2 SSD/dedicated iLO/serial port enablement board
4.11 M.2 SATA SSD enablement option
4.11.1 Installing an M.2 SATA SSD
4.12 Storage controller options
4.12.1 Installing a modular Smart Array controller option (type-a, AROC)
4.12.2 Installing a Smart Array standup storage controller
4.12.3 Configuring an HPE Smart Array Gen10 controller
4.13 Energy pack option
4.13.1 HPE Smart Storage Battery
4.13.2 Installing an energy pack
To Next Page
Loading...
