HP Series 37 - How to Configure PICDIAG

Operating Instructions
2.6 HOW TO CONFIGURE PICDIAG
You can configure and reconfigure the diagnostic according to your needs.
Table
2-1 describes the available PICDIAG commands. Those commands indicated with an asterisk (*)
are part of the default configuration. The PICDIAG provides this information when you enter the HELP
command.
COMMAND
EEPR*
EEPS*
ENPR*
"",AfT
GO
LOOP
NOLOOP
NOTRACE
PRINTER
RST
RUN
SEPS
SNPR
STATE
TEST
TRACE
* default
Table
2-1. DIAGNOSTIC COMMANDS
PARAMETERS DESCRIPTION
Enable Error Messages
Enable Error Pause
Enable non
-error messages
Return to DUS
Resume diagnostic execution
Loop on selected steps
Stop Loop
Suppress
I/O trace
Display errors
on printer
Enable pauses and messages
also suppress
printer
Restart diagnostic execution
Suppress
error pauses
Suppress non
-error messages
List status of program
step(s)
Select test steps to
run
Enable I/O activity trace
SEP 84
2-5