Error Codes
I
-
I A I
~
________________________________________________________________
~"
I
This appendix will cover all
error
codes associated
with
the
Series 3 7 Self Test.
The
error
codes
are
listed
according
to
the
test sequence
they
are associated with: TIC, PIC, CPU,
or
MEMORY.
TIC
ERROR
CODES
The TIC
error
codes
are
divided according
to
one
of
the
nine sections
of
the
TIC test
that
detected
the
error.
The
Slot Test will display one of
the
following
error
codes
if
the
TIC test fails. Note
that
the
Tests are
run
in
the
same sequence as
the
test sections
and
that
the
test stops on
the
first
failure
found.
TIC
Test
Section 1
This
is
the
initialization test.
It
will initialize
the
TIC
and
then
check
that
the
registers
contain
expected
data.
Code
Error
0108 Register 8 initialization
error
(expected $0800)
0109 Register 9 initialization
error
(expected $0800)
010A Register A initialization
error
(expected
$FFOO)
010C Register C initialization
error
(expected $0000)
0100
Register D initialization
error
(expected $ 0000)
010E Register E initialization
error
(expected $ 5004)
010F Register F initialization
error
(expected $5004)
TIC
Test
Section 2
This section performs tests on: basic operations, test OBII, IPOLL, SMSK & KMSK.
Code
Error
0201 SMSK/RMSK test, TIC did
not
respond
with
mask
bit
set
0202 SMSK/RMSK test, TIC did
not
respcnd v!ith mask bit cleared
0203 TIC did
not
set IRQ
0204
Improper IPOLL response (no, wrong,
or
multiple channels)
0205 Improper
OBn
response
NOV 84
A-I
To Next Page
Loading...
