HP Series 37 - Command Descriptions; Maintenance Mode Commands

COMMAND DESCRIPTIONS
INTRODUCTION
This section provides descriptions of each section of the Series 37 Self Test code. Included here are
definitions
of the two modes, Maintenance Mode and Test Mode, and their associated commands.
Examples
of error messages can be found in Appendi.' A.
MAINTENANCE MODE COMMANDS
Maintenance Mode is indicated by the "H for help->" prompt. Maintenance Mode initializes the TIC
for communication
with the System Operator and allows the following commands:
AR (Retry AutoRestart)
Coldstart
Coolstart
Disc
Dump
DW
EW
Help
Load
Newsystem
Automatic Warmstart
Panel
Reload
Run
Speed
Start
Tape
Test
Update
Warmstart
The Autowarmstart feature of Series 37 systems is enabled by the EW (Enable Warmstart) command.
Automatic
warmstart is disabled with DW (Disable Warmstart). The state of the Automatic Warmstart is
maintained during power off. If Autowarmstart is enabled, the Series 37 will issue the following prompt
after being powered on and PON is successfully completed:
WARMSTART? (yiN)
The user has 15 seconds to abort the automatic warmstart. If the user types anything other than "y"
[RETURNI , or IRETURNI alone, the system will abort the automatic warmstart, return to Maintenance Mode,
and display the
"H for Help" prompt. If the user types nothing the system will perform an automatic
warmstart after waiting 15 seconds. The commands that affect the Automatic Warmstart feature are:
EW
DW
Enable autoWarmstart
Disable autoWarmstart
NOTE
The Automatic Warmstart feature is indepedent of the keyswitch position.
NOV 84
3-\