HP Series 37 - Help; Load

Command Descriptions
Help
The HELP command lists all of the commands along with their parameters.
HELP displays the version code of the currently loaded microcode or "mainset microcode is NOT
loaded" if no microcode is loaded and then displays all of the commands available in Maintenance Mode.
2-LOCAL (from Normal)
H
for help->~
mainset microcode is NOT loaded
Auto warmstart disabled
last system stop code {hex)=0022
AR - Re-attempt Auto Restart,
COL[dstart] ,
COO[lstart] ,
DI[sc] - Start from Disc,
DU[mp] [chan, dev],
DW - disable auto warmstart,
EW - enable auto warmstart,
L[oad] [chan, dev[,{P[erm] ]].
C[hange]}
NEW [system] ,
2
OCAL (from Normal)
H for help- >
load
PArnell - Enter soft-panel,
REL road] ,
RUN,
SP[eed] ,
ST[art] [chan, dev[,{P[erm] ]],
C[hange]}
TA[pe] - Load from Tape,
TE[st],
lIOD[ate] ,
WAR[mstart] ,
The LOAD command loads the system microcode and software from the indicated or default tape unit and
allows the System Operator to perform COLDSTART, RELOAD, or UPDATE operations for MPE or to run
DUS.
If channel and device are specified, LOAD uses these parameters as the channel and device for the
LOAD. The default LOAD channel and device are also updated in the TOC register C if the optional
perm or change parameters are specified.
The LOAD command allows the System Operator to perform a LOAD using the default LOAD device
number stored in the TOC RAM. specify a different device, or just change the default device. The LOAD
is performed by loading the load execution code, the WCS boot code, and transferring control to the load
execution code.
The load execution code tests for the valid l.OAD parameter and updates the .!'. '3d device in the TOC
RAM if requested. Control is then transferred to the WCS boot code. If a parameter error occurred or jf
only a change to parameters was requested. contrnl is pas~ed back h' M~inten8nce Mr)de.
If the parameters are valId and If a LOAD or START is l.O be dOlle, control is passed to the \VCS boot code
which loads the HF3000 instrudil"l set from the disc or tape and proceeds with the LOAD or START.
NOV 84
3--+