HP Series 37 - Newsystem; Panel; Reload

Command Descriptions
The load is performed with the normal operator (INITIAL) dialogue allowing for changes to the software
configuration.
The
correct syntax for this command is:
LOAD [chan,device] [{P[erm]},{C[hange]}]
Newsystem
The NEWSYSTEM command operates like the LOAD command with the following exceptions:
• No ohannel or de/Jioe parameters are allowed.
o The
default LOAD device is always used .
• This command will only work with a FOS tape built especially for the Series 37. If NEW is
attempted with other RELOAD tapes, the operator (INITIAL) dialogue will be invoked by
INITIAL.
This
command performs a RELOAD function ~l·asing any existing user files
on
the system discs. It should be used only for the initial software
installation.
The
correct syntax for this command is:
NE[wsystem]
Panel
The PANEL command enters the Softpanel Mode. The commands available in Softpanel Mode are
described in Section IV "SOFTPANEL".
Reload
The RELOAD command operates exactly like the LOAD command with the following exceptions:
Q No channel or device parameters are a!!cwed.
~ The default LOAD device is always used .
.. No opportunity is given to change the software configuration (no INITIAL dialogue).
The
corn'ct syntax for this command is:
REL[oad]
NOV 84
3-5