HP Series 37 - Pon; Command Descriptions

Command Descriptions
PON
The Test Mode paN command executes the Power-on Self Test count times. This command is much like
the
ALL Test Mode command with the exception that the Power-on CPU test is executed in place of the
manually executed
CPU test and IOMAP is not executed. The PON test is initiated by toggling the PON
line.
NOTE
This command can not be run from keyswitch positions "3" or "1" from "3"
(REMOTE and LOCAL from REMOTE, respectively). The correct syntax
for this command
is:
PON [oount]
The following illustrates the use of paN:
2-LOCAL (from Normal)
Self Test ->PON
Power on Self Test
Memory Test passed
Number of banks =
Slot 1 Channel
Slot 4 Channel
1
4
4
2-LOCAL (from Normal)
Self Test ->
- Terminal Interface Controller
- Peripheral Interface Channel
NOV 84
3-15/16