Command Descriptions
The following illustrates the use of
IOMAP:
1-NORMAL
Test
->!
System
I/O
Configuration
Number
of
banks = 4
Load: Cilannel 4
Device
3
Start/Dump:
Channel 4
Device
1
Slot
1 Channel
Slot
4 Channel 4
Dev
ice
3 10=0260
1-NORMAL
Test
->
10=4
-
Terminal
Interface
Controller
10=2 -
Peripheral
Interface
Channel
- 9144
Cartridge
TapP.
Unit
Memory
The Test Mode
MEMORY
command
~xecutes
the Power-on Memory Test which first determines the amount
of memory installed, initializes the memory, performs an Address Test, performs a
Pattern
Test, and then
performs
an
Error
Detection And Correction Test (EDAC). The memory is
left
with 30F8 (halt
8)
in all
locations.
The full memory test
is
run
and a pass/fail message
is
sent to the System Console.
If
a failure occurrs the
number
of
the
failing section is displayed.
The test may be looped by specifying the desired number of loops in
oount. Count must be an integer
between
I
and
9999
with
I being the default. A space
is
required before specifing oount.
Return
is to the Test Mode prompt.
The correct syntax for this command
is:
M[emory] [ oountJ
The following illustrates the use of
MEMORY:
'\lOV
84
3-14
1-NORMAL
Test
->~
Memory
Test
passed
1-NORMAL
Test
->
To Next Page
Loading...
