HP Series 37 - Update; Warms Tart; Test Mode Commands

Command Descriptions
Update
The UPDATE command operates exactly like the LOAD command with the following exceptions:
• No channel or device parameters are allowed.
• The default LOAD device always used.
• No opportunity is given to change the software configuration (no INITIAL dialogue).
The correct syntax for this command is:
UPD[ate)
Warms tart
The WARMSTART command operates exactly like the START command with the following exceptions:
• No channel or device parameters are allowed.
• The default START device is always used.
• A warmstart can be run without any interaction by the System Operator (no I~ITIAL
dialogue).
The
correct syntax for this command is:
WAR[mstart)
TEST MODE COMMANDS
Test Mode is entered with the Maintenance Mode TEST command. The Test Mode allows all of the Self
Test steps to be manually directed. The following Test Mode commands will be discussed in greater detaji:
NOV 84
3-8
All
Channel
CPU
Exit
NOTE
Help
Iomap
Memory
PON