HP Series 37 - Page 15

Operating Instructions
Table ]-3. Maintenance Mode Commands.
Command
I
---li
,
!
Refer to Note I below.
DESCRIPTION
AR
COLDSTART
Retry Auto Restart.
Perform COLDST ART using LOAD device.
::::::: ::~':::i:: :~I:::T~::ede::;er::f:o:: ~:::0~\beI0W. I
COOLSTART
DISC
!
DUMP
Perform DUMP using indicated or START device.
DW
Disable auto Warmstart.
EW
Enable auto Warmstart.
HELP
Display HELP messages.
LOAD
Perform LOAD (has options). Refer to Note 2 below.
NEWSVST£M Perform initial software installatIOn.
PANEL Enter Soft Panel.
RELOAD
Perform RELOAD using LOAD device. Refer to Note 1 belc,w
RUN
RUN system after Control B halt.
SPEED
All"w the System Operator to lhange System Console ,peed
START Perform START (has options). Refer to Note 2 below
TAPE Perform LOAD USlIlg LOAD deVIce
Refer to '\;ote 2 below.
TEST Go to Self Test mode.
UPDATE
Perform UPDATE using LOA;) device. Refer to Note 1 ';p.!(\w.
WARMSTART
Perform WARMSTART using START device. Refer to Nc'te 1 below.
Notes:
1. These commands do not allow changes to the software configuration (no I"-'lTl.\L
dialogue).
NOV 3i
2-4