Event
code
Message and description Details and solution
4030 Move cartridge operation failed due to
media error.
Remove the cartridge and inspect it for
damage. If the operation fails again, retry
the operation with another cartridge.
4031 Exchange media failed due to media error.
4037 Loss of redundant datapath. Verify that both FC ports are correctly
cabled to the SAN.
4038 The drive configuration failed because of
unsupported ADPF features selected.
Advanced path failover, ADPF and ACPF,
are only supported on LTO-6 tape drives.
• If the drive is an LTO-6 drive, verify that
the drive is running the latest firmware
version and that all drives in the partition
support advanced path failover. To
update the drive configuration, run the
Advanced Partition Wizard.
• If the drive is not an LTO-6 drive, either
remove it from the partition or disable
advanced path failover for the partition.
Run the Advanced Partition Wizard to
update the partition and drive
configuration.
4039 The drive configuration failed because of
unsupported ACPF features selected.
4040 Data path failover occurred. Check the cabling and all network
components between the affected drive and
host computer.
4041 Wellness test failed because power supply
redundancy test failed.
• Ensure that all power supplies are
installed properly.
• Ensure that each power supply is
connected to a valid AC power source.
4042 ESKM feature not licensed. Disable ESKM or install the necessary
ESKM license.
4043 Control path failover occurred.
This event applies to Advanced Control Path
Failover.
If the failover was unplanned or unexpected,
verify that the host still sees both the active
and passive drives. If necessary, reconfigure
a different passive drive for the partition.
Check the cabling and all network
components between the affected drive and
host computer.
Table Continued
220 Event codes
To Next Page
Loading...
