Event
code
Message and description Details and solution
4064 KMIP feature is not licensed. Disable the KMIP feature or install the
necessary license.
4065 A tape alert event was reported by a drive. Check event details for additional
information.
4066 Automatic control path failover by disabling
LUN drive failed; partition may be
disconnected from host.
Check cabling and all network components
between the affected drive and host
computer.
4067 Cleaning cartridge will soon be expired and
should be replaced.
Replace the cleaning cartridge.
4068 No cleaning cartridge found. When initiating a cleaning operation, the
library will use an unexpired cleaning
cartridge from the same partition as the tape
drive. If the partition does not contain an
unexpired cleaning cartridge, the library will
use an unexpired cleaning cartridge from an
unpartitioned area of the library. The library
will not use a cleaning cartridge from a
different partition. When enabling auto
cleaning, either ensure that each partition
has an unexpired cleaning cartridge or place
at least one unexpired cleaning cartridge in
an area that is not assigned to a partition.
The cleaning cartridge label must begin with
the letters “CLN” for the library to recognize
it as a cleaning cartridge. For more
information about auto cleaning, see
Configuring auto cleaning on page 109.
1. Verify that a properly labeled unexpired
cleaning cartridge is available in the
same partitions as the drives requesting
cleaning or in an unpartitioned area of
the library.
2. Perform a load and unload on any drives
that need cleaning to initiate
autocleaning.
4069 Configuring the drive default map ID was not
possible.
Ensure that the drive is powered on, is
communicating with the library, and has
current firmware. If this error persists,
disable Secure Manager for the library and
re-enable it. Secure Manager is only
supported on LTO-4 and later generation FC
drives.
Table Continued
Event codes 223
To Next Page
Loading...
