Event code Message
9022 MSL Encryption Kit backup has been done. The encryption keys on the key server token
have been saved to a key server token backup file.
9023 MSL Encryption Kit restore has been done. The encryption keys have been restored to the
key server token from a key server token backup file.
9024 Drive support ticket created.
9025 Library test started.
9026 Library test successfully finished.
9027 Library test stopped by user.
9028 Configuration backup to base module was successful.
9029 Configuration restore operation from base module was successful.
9030 An incompatible MSL Encryption Token was inserted.
9031 Library health status changed to status “OK”.
9032 Library health status changed to status “Warning”.
9033 Library health status changed to status “Critical”.
9034 New system controller detected. The library detected a new module controller
9035 New library chassis detected. The library detected a new expansion module.
9036 Key on key server created.
9037 The library was rebooted from the OCP.
9038 The library was rebooted through the user interface.
9039 Token key creation attempt failed due to media being loaded in one or more drives.
9040 Control path switched over from active to passive drive. This event code is used when the
user initiates the failover from the RMI.
9041 Key on KMIP server created.
9042 Drive cleaning completed.
9043 Drive cleaning was started. There will not be an additional event generated when cleaning
successfully finishes. In case of an error, one or more warning events will be generated.
9044 Key from MSL encryption token migrated.
Table Continued
236 Event codes
To Next Page
Loading...
