138 SYSTEM DIAGNOSTICS AND TROUBLESHOOTING
1203—Game Port Address
Conflict Detected
Device IRQ address conflicts with
another device.
Reset the IRQ
1720 SMART Hard Drive
Detect Imminent Failure
Hard drive is about to fail. (Some hard
drives have a firmware patch that will
fix an erroneous error message.)
1 Determine if hard drive is giving correct error
message. Run the Drive Protection System test if
applicable.
2 Apply firmware patch if applicable (see http://
www.hp.com/support).
3 Back up contents and replace hard drive.
1721—SMART SCSI Hard
Drive detects imminent failure
Hard drive is about to fail. (Some hard
drives have a firmware patch that will
fix an erroneous error message.)
1 Determine if hard drive is giving correct error
message. Run the Drive Protection System test if
applicable.
2 Apply firmware patch if applicable (see http://
www.hp.com/support).
3 Back up contents and replace hard drive.
1780—Disk 0 Failure The drive is not installed correctly or
has failed.
1 Make sure that any jumpers are set correctly, and
that power and drive cables are connected, both to
the drive and the system board.
2 Verify that the cables are the correct cables for
your computer model.
If this message persists, you may need service for your
workstation.
1781—Disk 1 Failure The drive is not installed correctly or
has failed.
1 Make sure that any jumpers are set correctly, and
that power and drive cables are connected, both to
the drive and the system board.
2 Verify that the cables are the correct cables for
your computer model.
If this message persists, you may need service for your
workstation.
1782—Disk Controller Failure Hard drive circuitry error. 1 Run Computer Setup (F10 Setup).
2 Clear CMOS.
3 Check cable seating/jumper settings.
4 Run hard drive diagnostics.
5 Disconnect additional drives.
6 Run the Drive Protection System test if available.
7 Check http://www.hp.com\support\
techpubs\customer_advisories for possible changes
when using Windows NT 4.0 Service Pack 4.
8 Replace the hard drive.
9 Replace the system board.
1785—Multibay incorrectly
installed
No other IDE device may be attached
to the same IDE controller.
Attach the Multibay as device 0 on the secondary IDE
controller.
Table 5-18 POST Error Messages (Continued)
Screen Message Probable Cause Recommended Action
To Next Page
Loading...
