7. Remove the carrier (3).
Reverse this procedure to install solid-state drives 3 and 4 and the solid-state drive carrier.
Hard drive
To remove the hard drive, use these procedures and illustrations.
Table
5-4 Hard drive, hard drive bracket and hard drive cable descriptions and part numbers
Description Spare part number
NOTE: The hard drive spare part kit does not include the hard drive bracket or hard drive cable. The hard drive bracket is included in the
Hard Drive Harware Kit, spare part number M20091-001. The hard drive cable is included in the Cable Kit, spare part number
M20105-001.
2 TB, SATA, 5400 RPM, 7.0 mm 912487-850
1 TB, SATA, 7200 RPM, 9.5 mm 766644-001
500 GB, SATA, 7200 RPM, 9.5 mm 703267-001
500 GB, SATA, 7200 RPM, 9.5 mm, FIPS 820572-001
Before removing the hard drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40).
3. Remove the battery (see Battery on page 41).
4. Remove the solid-state drive carrier (see Solid-state drives 3 and 4 on page 42).
Remove the hard drive:
44 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts ENWW
To Next Page
Loading...
