5. Keyboard (see Keyboard on page 54)
6. Bottom case (see Bottom case on page 66)
Remove the touchpad cable:
1. Detach the touchpad cable (1) from the top cover. (The touchpad cable is attached to the top cover with
double-sided adhesive.)
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
3. Release the ZIF connector (3) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the touchpad.
4. Remove the touchpad cable (4).
Reverse this procedure to install the touchpad cable.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table
6-4 Touchpad description and part number
Description Spare part number
NOTE: The touchpad spare part kit does not include the touchpad bracket or touchpad cable. The touchpad bracket is not available as a
spare part. The touchpad cable is available in the Cable Kit, spare part number M20105-001.
For use only on computer models equipped with NFC capability (includes NFC antenna) M38137-001
For use only on computer models not equipped with NFC capability M36390-001
Before removing the touchpad, follow these steps:
74 Chapter 6 Removal and replacement procedures for authorized service provider parts ENWW
To Next Page
Loading...
