HP ZBook Fury 17 G7 - Card Reader Board Removal; Card Reader Board Removal (Authorized)

4. Detach the NFC module (4) from the top cover. (The NFC module is attached to the top cover with double-
sided adhesive.)
Reverse this procedure to install the NFC module and cable.
Card reader board
To remove the card reader board, use this procedure and illustration.
Table
6-6 Card reader board description and part number
Description Spare part number
Card reader board (includes cable) M20106-001
Before removing the card reader board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40), and then remove the following components:
1. Battery (see Battery on page 41)
2. Solid-state drives 3 and 4 (see Solid-state drives 3 and 4 on page 42)
3. Solid-state drive carrier (see Solid-state drives 3 and 4 on page 42)
4. Hard drive (see Hard drive on page 44)
5. Keyboard (see Keyboard on page 54)
6. Bottom case (see Bottom case on page 66)
Remove the card reader board:
78 Chapter 6 Removal and replacement procedures for authorized service provider parts ENWW