5. Keyboard (see Keyboard on page 54)
6. Bottom case (see Bottom case on page 66)
Remove the hard drive cable:
1. Disconnect the hard drive cable (1) from the system board.
2. Release the hard drive cable from the retention clips (2) built into the top cover.
3. Remove the two Phillips M2.5 × 6.0 screws (3) that secure the hard drive cable to the top cover.
4. Remove the hard drive cable (4).
Reverse this procedure to install the hard drive cable.
Touchpad cable
To remove the touchpad cable, use this procedure and illustration.
The touchpad cable is available in the Cable Kit, spare part number M20105-001.
Before removing the touchpad cable, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40), and then remove the following components:
1. Battery (see Battery on page 41)
2. Solid-state drives 3 and 4 (see Solid-state drives 3 and 4 on page 42)
3. Solid-state drive carrier (see Solid-state drives 3 and 4 on page 42)
4. Hard drive (see Hard drive on page 44)
ENWW Component replacement procedures 73
To Next Page
Loading...
