4. Pull the drive away from the socket to remove it (1).
Solid-state drives are designed with a notch (2) to prevent incorrect installation.
A thermal pad services solid-state drive 2 and is located on the solid-state drive compartment cover. This
pad should be inspected each time that the cover is removed. This pad is intended to be reused if it is not
damaged. If this pad is damaged and any residue remains on the solid-state drive (1) or the cover (2), it
should be thoroughly removed and replaced.
To install the solid-state drive, reverse the removal procedures.
Memory modules 2 and 4
To remove memory modules 2 and 4, use this procedure and illustration.
ENWW Component replacement procedures 51
To Next Page
Loading...
