Reverse this procedure to install the SD card board cable.
SD card board
To remove the SD card board, use this procedure and illustration.
NOTE: The SD card board spare part kit includes SD card board.
Table 6-2 SD card board description and part number
Description Spare part number
SD card board
NOTE: The SD card board spare part kit does not include the SD card board cable. The SD card board cable is
available in the Cable Kit, spare part number M20105-001.
M17093-001
Before removing the SD card board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40), and then remove the following components:
1. Battery (see Battery on page 41)
2. Solid-state drives 3 and 4 (see Solid-state drives 3 and 4 on page 42)
3. Solid-state drive carrier (see Solid-state drives 3 and 4 on page 42)
4. Hard drive (see Hard drive on page 44)
5. Keyboard (see Keyboard on page 54)
6. Bottom case (see Bottom case on page 66)
Remove the SD card board:
1. Remove the SD card slot bezel (1).
The SD card slot bezel is included in the Plastics Kit, spare part number M20093-001.
2. Detach the SD card board cable (2) from the top cover. (The SD card board cable is attached to the top
cover with double-sided adhesive.)
3. Release the ZIF connector (3) to which the SD card board cable is connected, and then disconnect the SD
card board cable from the system board.
4. Remove the two Philllips M2.0 × 2.9 broad head screws (4) that secure the SD card board to the top cover.
ENWW Component replacement procedures 69
To Next Page
Loading...
