Before removing the NFC module cable, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40), and then remove the following components:
1. Battery (see Battery on page 41)
2. Solid-state drives 3 and 4 (see Solid-state drives 3 and 4 on page 42)
3. Solid-state drive carrier (see Solid-state drives 3 and 4 on page 42)
4. Hard drive (see Hard drive on page 44)
5. Keyboard (see Keyboard on page 54)
6. Bottom case (see Bottom case on page 66)
Remove the NFC module cable:
1. Release the ZIF connector (1) to which the NFC module cable is connected, and then disconnect the NFC
module cable from the system board.
2. Release the ZIF connector (2) to which the NFC module cable is connected, and then disconnect the NFC
module cable from the SD card board.
3. Detach the NFC module cable (3) from the top cover. (The NFC module cable is attached to the top cover
with double-sided adhesive.)
4. Remove the NFC module cable (4).
Reverse this procedure to install the NFC module cable.
NFC module
To remove the NFC module, use this procedure and illustration.
76 Chapter 6 Removal and replacement procedures for authorized service provider parts ENWW
To Next Page
Loading...
