NOTE: The NFC module spare part kit includes NFC module.
Table 6-5 NFC module description and part number
Description Spare part number
NFC module
NOTE: The NFC module spare part kit does not include the NFC module cable. The NFC module cable is
available in the Cable Kit, spare part number M20105-001.
M17065-001
Before removing the NFC module, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40), and then remove the following components:
1. Battery (see Battery on page 41)
2. Solid-state drives 3 and 4 (see Solid-state drives 3 and 4 on page 42)
3. Solid-state drive carrier (see Solid-state drives 3 and 4 on page 42)
4. Hard drive (see Hard drive on page 44)
5. Keyboard (see Keyboard on page 54)
6. Bottom case (see Bottom case on page 66)
Remove the NFC module:
1. Release the ZIF connector (1) to which the NFC module cable is connected, and then disconnect the NFC
module cable from the system board.
2. Release the ZIF connector (2) to which the NFC module cable is connected, and then disconnect the NFC
module cable from the NFC module.
3. Detach the NFC module cable (3) from the top cover. (The NFC module cable is attached to the top cover
with double-sided adhesive.)
ENWW Component replacement procedures 77
To Next Page
Loading...
