1. Release the ZIF connector (1) to which the card reader board cable is connected, and then disconnect the
card reader board cable from the system board.
2. Detach the card reader board cable (2) from the top cover. (The card reader board cable is attached to the
top cover with double-sided adhesive.)
3. Remove the four Phillips M2.0 × 2.9 broad head screws (3) that secure the card reader board to the top
cover.
4. Remove the card reader board (4) and cable.
Reverse this procedure to install the card reader board and cable.
Fan/heat sink assembly
To remove the fan/heat sink assembly, use these procedures and illustrations.
Table
6-7 Fan/heat sink assembly descriptions and part numbers
Description Spare part number
All fan/heat sink assembly spare part kits include replacement thermal material.
For use on computer models equipped with AMD graphics cards M20098-001
For use on computer models equipped with N19E graphics cards M20097-001
For use on computer models equipped with N19P graphics cards M20096-001
For use on computer models equipped with UMA graphics subsytems M20095-001
Before removing the fan/heat sink assembly, follow these steps:
ENWW Component replacement procedures 79
To Next Page
Loading...
