HP ZBook Fury 17 G7 - Fingerprint Reader Module Removal; Fingerprint Reader Module Removal (Authorized)

3. Remove the ngerprint reader module cable (3).
Reverse this procedure to install the ngerprint reader module cable.
Fingerprint reader module
To remove the ngerprint reader module, use this procedure and illustration.
Table
6-3 Fingerprint reader module description and part number
Description Spare part number
Fingerprint reader module
NOTE: The ngerprint reader module spare part kit does not include the ngerprint reader module cable.
The ngerprint reader module cable is available in the Cable Kit, spare part number M20105-001.
M17064-001
Before removing the ngerprint reader module, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40), and then remove the following components:
1. Battery (see Battery on page 41)
2. Solid-state drives 3 and 4 (see Solid-state drives 3 and 4 on page 42)
3. Solid-state drive carrier (see Solid-state drives 3 and 4 on page 42)
4. Hard drive (see Hard drive on page 44)
5. Keyboard (see Keyboard on page 54)
6. Bottom case (see Bottom case on page 66)
ENWW Component replacement procedures 71