2. Press down on the module until the side retention clips snap into place (3).
Solid-state drive 1
To remove solid-state drive 1, use this procedure and illustration.
Table
5-11 Solid-state drive description and part number
Description Spare part number
1 TB, M.2 2280, PCIe, NVMe-3×4, SS with TLC L85348-001
512 GB, M.2 2280, PCIe-3×4, SS with TLC L85360-001
512 GB, M.2 2280, PCIe, NVMe, SED with TLC L85368-002
256 GB, M.2 2280, PCIe-3×4, SS with TLC L85350-001
256 GB, M.2 2280, PCIe, NVMe, SED with TLC M07245-001
Before removing solid-state drive 1, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40).
3. Remove the battery (see Battery on page 41).
4. Remove the keyboard (see Keyboard on page 54).
Remove solid-state drive 1:
1. Remove the Phillips M2.0 × 2.9 screw (1) that secures the solid-state drive 1 cover to the computer.
2. Lift the right side (2) of the cover until it rests at an angle.
62 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts ENWW
To Next Page
Loading...
